54-94
L I G H T I N G S Y S T E M Fog
FOG LIGHT
R E M O V A L A N D I N S T A L L A T I O N
Removal steps
Fog light
2. Grommet
Stud
Bulb installation
S E R V I C E P O I N T S O F R E M O V A L
1. REMOVAL OF FOG LIGHT
The fog light assembly can be removed by pressing the
stud pin from the reverse side of the bumper.
REPLACEABLE BULB REPLACEMENT
(1) Remove the fog light assembly, and then remove the cap.
(2) Remove the bulb installation spring, and pull out the bulb.
Caution
1. Never hold the halogen light bulb with a bare hand,
dirty glove, etc.
2. If the glass surface is dirty, be sure to clean it with
alcohol, paint thinner, etc., and install it after drying
it thoroughly.
Be sure to attach the socket cover.
NOTE
Be sure to install the socket cover securely because, if it is
not, an insecure installation could cause such problems as
clouding of the lens, or intrusion of moisture to inside the
light unit.
TSB Revision
