LIGHTING SYSTEM Rear Combination
tight
REAR COMBINATION LIGHT
REMOVAL AND INSTALLATION
Pre-removal and Post-installation
Operation
@Removal and Installation of Trunk Room
Trim (Refer to GROUP
Rear combination light
I
SERVICE POINTS OF
1. REMOVAL OF REAR COMBINATION LIGHT
Attach tape (cloth adhesive tape) or similar material
around the rear combination light.
Using a flat-tip
screwdriver, slowly pry the rear
combination light part while pulling the rear combina-
tion light toward you in order to remove it.
Caution
Take particular care when prying the rear combina-
tion light because excessive force or careless prying
might cause scarring of
the
rear combination light
or of the body surface.
SERVICE POINTS OF INSTALLATION
1. INSTALLATION OF REAR
LIGHT
Remove any remaining adhesive material from the body
surface and the rear combination light, and then use
unleaded petrol to remove any grease or oil from the
body side adhesive area.
sealant to the area indicated in the illustration.
Specified sealant:
ATD Part
or equiva-
lent
Install the rear combination light.
TSB Revision