α
2 Simple Application Controllers
Function Blocks 6
6 - 33
Setup of the Offset Gain Function Block directly from the
α
2
Series Controller
1 ) Allocate the input pin to be used for the function block.
2 ) Press the “OK” key with the cursor in the function block. The function block edit screen is
displayed as shown.
3 ) Press the “OK” Key and enter the function block settings using the “ and ” keys. The
parameters A, B, X, C, Low limit and High limit have to be specified for the linear
expression to operate correctly..
4 ) Using the “ and ” arrows highlight A and press the “OK” key. A Direct Set using the “+
and -” keys can be entered, subsequently press the “OK” key to accept the Direct Set
value. (Repeat operation for B)
5 ) Highlight X using the “ and ” keys and press the “OK” key to set the Analog In channel.
6 ) The Analog In channel can be selected using the “+ and -” keys, subsequently press the
“OK” key to accept the channel.
7 ) Highlight C using the “ and ” keys and press the “OK” key to set the constant value.
8 ) A Direct Set using the “+ and -” keys can be entered, subsequently press the “OK” key to
accept the Direct Set value.
B 0 0 1 : OG
S e t u p
F B
C h a n g e N o
D e l e t e
F B
B 0 0 1 : OG
y = A / B
∗
x
L i m i t : L ,
+ C
H
0
B 0 0 1 : OG
C o n s t a n
D i r e c t S e
t A
t
1
B 0 0 1 : OG
y = A / B
∗
x
L i m i t : L ,
+ C
H
0
A 0 2 :
B 0 0 1 : OG
I n p u t V a
A n a l o g
I
l
n
A 0 1
0
B 0 0 1 : OG
y = A / B
∗
x
L i m i t : L ,
+ C
H
0
B 0 0 1 : OG
C o n s t a n
D i r e c t S e
t C
t
0
