System Product Guide
6-15
PCI Configuration Status and Error Messages
The following PCI messages are displayed as a group with bus, device and
function information.
Message
Explanation
Floppy Disk Controller Resource Conflict
The floppy disk controller has requested a
resource that is already in use.
NVRAM Checksum Error, NVRAM Cleared
The ESCD data was reinitialized because of
an NVRAM checksum error. Try rerunning the
ICU.
NVRAM Cleared By Jumper
The “Clear CMOS” jumper has been moved to
the ON position and CMOS RAM has been
cleared.
NVRAM Data Invalid, NVRAM Cleared
Invalid entry in the ESCD.
Parallel Port Resource Conflict
The parallel port has requested a resource that
is already in use.
PCI Error Log is Full
This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
PCI I/O Port Conflict
Two devices requested the same resource,
resulting in a conflict.
PCI IRQ Conflict
Two devices requested the same resource,
resulting in a conflict.
PCI Memory Conflict
Two devices requested the same resource,
resulting in a conflict.
Primary Boot Device Not Found
The designated primary boot device (hard disk
drive, diskette drive, or CD-ROM drive) could
not be found.
Summary of Contents for apricot VS660
