13
When the pairing process has been success-
fully performed, the set temp.display shows
"
" . If unsuccessfully, "
" will appear, so
correctly repeat the same process.
When the pairing process failed, the wireless
receiver keeps the pairing mode active for 5
minutes unless cancelled.
This makes it possible to continuously pair
multiple wireless remote controllers.
<Pairing is successful>
<Pairing is unsuccessful>
<<Main causes that prevent successful pairing>>
● The wireless receiver does not enter the pairing mode.
►Press the
button for 3 seconds or more to enter the pairing mode.
Note that the wireless receiver performs a pairing process only if the main system is off.
● Pairing is attempted outside the transmission range of the wireless receiver.
►Adjust the distance between the wireless receiver and remote controller, so try again.
If the distance is excessively short, pairing may fail. Keep the distance of about 50 cm.
● The wireless remote controller has been already paired with the wireless receiver.
►The paired wireless remote controller is not allowed to be paired with the same wireless
receiver again with another address.
The wireless remote controller does not clear the pairing information. Only the wire-
less receiver does. However, when pairing the paired wireless remote controller with a
new wireless receiver, the pairing information does not need to be cleared.
Even when power fails or when the batteries run down, the pairing information will not
be lost.
