5
GB
Warning:
•
Do not splash water over the unit and do not touch the unit with wet
hands. An electric shock may result.
•
Do not spray combustible gas close to the unit. Fire may result.
•
Do not place a gas heater or any other open-flame appliance where
it will be exposed to the air discharged from the unit. Incomplete
combustion may result.
Warning:
•
Do not remove the front panel or the fan guard from the outdoor unit
when it is running. You could be injured if you touch rotating, hot or
high-voltage parts.
• Never insert fingers, sticks etc. into the intakes or outlets, otherwise
injury may result, since the fan inside the unit rotates at high speed.
Exercise particular care when children are present.
•
If you detect odd smells, stop using the unit, turn off the power switch
and consult your dealer. Otherwise, a breakdown, electric shock or fire
may result.
•
When you notice exceptionally abnormal noise or vibration, stop opera-
tion, turn off the power switch, and contact your dealer.
•
Do not over-cool. The most suitable inside temperature is one that is
within 5 °C [9 °F] of the outside temperature.
•
Do not leave handicapped people or infants sitting or standing in the path
of the airflow from the air-conditioner. This could cause health problems.
Caution:
• Do not direct the airflow at plants or caged pets.
•
Ventilate the room frequently. If the unit is operated continuously in a
closed room for a long period of time, the air will become stale.
In case of failure
Warning:
•
Never remodel the air conditioner. Consult your dealer for any repair
or service. Improper repair work can result in water leakage, electric
shock, fire, etc.
•
If the remote controller displays an error indication, the air conditioner
does not run, or there is any abnormality, stop operation and contact
your dealer. Leaving the unit as it is under such conditions can result
in fire or failure.
•
If the power breaker is frequently activated, get in touch with your
dealer. Leaving it as it is can result in fire or failure.
•
If the refrigeration gas blows out or leaks, stop the operation of the air
conditioner, thoroughly ventilate the room, and contact your dealer.
Leaving the unit as it is can result in accidents due to oxygen deficien
-
cy.
When the air conditioner is not to be used for a long
time
•
If the air conditioner is not to be used for a long time due to a seasonal
change, etc., run it for 4 - 5 hours with the air blowing until the inside is
completely dry. Failing to do so can result in the growth of unhygienic,
unhealthy mold in scattered areas throughout the room.
•
When it is not to be used for an extended time, keep the [power supply]
turned OFF.
If the power supply is kept on, several watts or several tens of watts
will be wasted. Also, the accumulation of dust, etc., can result in fire.
•
Keep the power switched ON for more than 12 hours before starting
operation. Do not turn the power supply OFF during seasons of heavy
use. Doing so can result in failure.
1.3. Disposing of the unit
Warning:
When you need to dispose of the unit, consult your dealer. If pipes are re-
moved incorrectly, refrigerant (fluorocarbon gas) may blow out and come
into contact with your skin, causing injury. Releasing refrigerant into the
atmosphere also damages the environment.
2. Names and functions of various parts
Attachment and detachment of filter
[Fig. A] (P.3)
Caution:
• In removing the filter, precautions must be taken to protect your eyes
from dust. Also, if you have to climb up on a stool to do the job, be
careful not to fall.
• Turn off the power supply when the filter is changed.
3. How to operate
3.1. ON/OFF
Start an operation
1. Press the
b
[ON/OFF] button
P
Operation lamp lights up and operation starts.
Stop an operation
1. Press the
b
[ON/OFF] button again
Operation lamp goes off and operation stops.
•
Once the Buttons have been set, pressing of the [ON/OFF] Button only can
repeat the same operation thereafter.
•
During operation, the operation lamp above the [ON/OFF] button lights up.
Caution:
Even if the [ON/OFF] Button is pressed immediately after the operation is
once stopped, operation is not restarted for about 3 minutes. This function
protects the machine. It automatically starts operation after the lapse of
approximately 3 minutes.
3.2. Selecting operation
When selecting operation
1. Press the
3
[Mode (BACK)] Button
Consecutive press of the selecting operation Button switches the operation
over to
E
“ COOL”, “ DRY”, “ FAN”, (“ AUTO”), and (“ HEAT”).
For the contents of operation, check the display.
* DRY operation cannot be carried out by PEFY-P-NMHU-E-F.
For cooling
Press the
3
[Mode (BACK)] Button and bring up the “
COOL
” display.
ON/OFF
CHECK
CLEAR
MENU
ON/OFF
TEST
TEMP.
CLOCK
OPERATION
BACK
DAY
MONITOR/SET
1
E
2
3
6 8
B
P
7
FILTER
ERROR CODE
TIME
ON
OFF
Hr
AFTER
SUN MON TUE WED THU FRI
SAT
TIMER
AFTER
ONLY 1Hr.
˚C
˚F
WEEKLY
SIMPLE
AUTO OFF
FILTER
FUNCTION
˚C
˚F
Before starting operation
•
Start running after the “PLEASE WAIT” display has disappeared. The
“PLEASE WAIT” display briefly appears on the room temperature display
(max. 3 minutes) when the power is turned on and after a power failure. This
does not indicate any failure of the air-conditioner.
•
The choice of indoor unit operation mode is limited by the operation status
of the outdoor unit to which a given indoor unit is connected. If an outdoor
unit and some of the indoor units that are connected to the outdoor units are
already operating in the cooling mode, for example, only the cooling mode
is available for the rest of the units in the same group. If a different mode is
requested, the symbol that corresponds to the requested mode will blink,
notifying the user that the mode is currently unavailable. The same is true for
the dry and heating mode. This restriction, however, does not apply to the
models that support a simultaneous cooling/heating function.
* DRY operation cannot be carried out by PEFY-P-NMHU-E-F.
•
The outdoor units stop when all the indoor units connected to the counterpart
outdoor units stop.
•
During heating operation, even if the indoor unit is set to operation while the
outdoor unit is in defrosting operation, operation starts after the defrosting
operation of the outdoor unit has ended.
