9. Connections of Display Unit
9.7 Connecting with Floppy Disk Unit: FCU7-DA315-11 / FCU7-DA415-11 / FCU7-DA445-11
151
(2) Floppy disk unit mounting conditions
Mount the floppy disk unit within ±25° in respect to the perpendicular or horizontal position.
The unit cannot be used when the disk slot is tilted (other than perpendicular/horizontal position). (±0°)
Front
FDD unit
disk
Within 25
°
Within 25
°
(Note 1)
Only the mode 2 (720k/1.44M bytes) is available for MITSUBISHI floppy disk drive.
(Note 2)
MITSUBISHI will not provide performance guarantee and maintenance for commercially available
floppy disk drives. Commercially available devices may not be compatible with MITSUBISHI units or
suitable for FA environment for temperature- or noise-wise. In the case of using it, careful
performance check must be required by the machine tool builder.
(Note 3)
Do not pull out the floppy disk or turn OFF the power during access to the floppy disk. Failure to
observe this could cause the memory contents to be erased. In case of emergency, always perform
backups by having your important data duplicated, etc. as MITSUBISHI will not guarantee the
broken or lost data. Be sure to inform this matter to the end users.
CAUTION
Do not apply voltages to the connectors other than voltages indicated in this manual. Failure to observe this could
cause the devices to rupture or damage, etc.
Incorrect connections could cause the devices to damage. Connect the cable to the designated connector.
Do not connect or disconnect the connection cables between each unit while the power is ON.