Introduction
This manual is called MITSUBISHI CNC 700 Series CONNECTION MANUAL and covers the
items related to installation, connection and maintenance of this NC unit. Read this manual
thoroughly before using. For safe use, fully understand "Precautions for Safety" on the next
page first.
Details described in this manual:
CAUTION
For items described as "Restrictions" or "Usable State" in this manual, the instruction
manual issued by the machine tool builder takes precedence over this manual.
Items that are not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all option functions are added. Confirm the
specifications issued by the machine tool builder before use.
Refer to the Instruction Manual issued by each machine tool builder for details on each
machine tool.
Some screens and functions may differ depending on each NC system (or version), and
some functions may not be possible. Please confirm the specifications before use.
The numerical control unit is configured of the control unit, display unit, operation board, servo drive
unit, spindle drive unit, power supply unit + driver, servomotor, and spindle motor, etc.
In this manual, the following items are generically called the "controller".
•
Control unit
•
Display unit
•
Operation board
•
Numerical control unit peripheral devices (input/output unit, safety unit)
In this manual, the following items are generically called the "drive unit".
•
Servo drive unit
•
Spindle drive unit
•
Power supply unit + driver
In this manual, the following items are generically called the "motor".
•
Servomotor
•
Spindle motor
