EN-6
To 3D SYNC
terminal
To 3D emitter
terminal
Mini DIN 5-pin cable
4. Plug the power cord of the projector into the wall outlet and turn on the
power.
• The indicator on the 3D emitter will light green and the 3D emitter will be
ready to communicate with the 3D glasses.
5. Adjust the position and angle of the 3D emitter so that the 3D glasses can
receive the infra-red signal.
• The traveling distance of the infra-red signal from the 3D emitter is about
10 m in straight line from the front of the infra-red transmission part.
• You can adjust the angle of the infra-red transmission part as shown
below. Loosen the knob to adjust the angle and after finishing the
adjustment, tighten the knob.
Knob
Infra-red
transmission
part
• Secure the 3D emitter using the supplied screws (M3) as necessary.
Important:
• Do not put any object which obstructs the communication between the 3D
emitter and the 3D glasses.
• Do not place the 3D emitter near the remote control sensor of other devices.
• The transmission distance is decreased when the infra-red signal from the
3D emitter is transmitted to the 3D glasses by refl ecting on the screen. In
addition, the transmission distance in such case varies depending on the
characteristics of the screen.
Installation and connection (continued)
Screw holes
