3 INVERTER SETTING
INVERTER SETTING
10
3 INVERTER SETTING
3.1 Pre-Operation Setting
3.1.1 Inverter station number setting
Set the inverter station number before switching on the inverter and do not change the setting while power is on.
When setting the station number, the following points should be taken into consideration:
1) The station number may be set between 1 and 64.
Fully note that if the station number is changed during operation, data communication cannot be made with the new
station number.
2) Setting method
z
Set the arrow (
×
) of the corresponding switch to the required numeral.
Example:
y
For station number 1: Set (
×
) of
×
10 to "0" and (
×
) of
×
1 to "1".
y
For station number 26: Set (
×
)
×
10 to "2" and (
×
)
×
1 to "6".
Station number setting switches
0
9
8
7
6
5
4
3
2
1
0
9
8
7
6
5
4
3
2
1
×
10
×
1
z
Set station numbers consecutively in a connection sequence.
(The station numbers may also be set independently of the connection sequence.)
z
Note that the same station number cannot be repeated.
(If the same station number is repeated, proper communication cannot be made.)
z
Set each station number switch to the position of its numeral without error. If it is set to any
position between numerals, normal data communication cannot be made.
Good example
0
9
8
7
6
5
4
3
2
1
0
9
8
7
6
5
4
3
2
1
Bad example
