5.4 PLC Side Setting
5 - 41
5
E
T
H
E
RNET CONNEC
T
ION
: Necessary : As necessary : Not necessary
*2
Set the same network No. as that of the GOT.
*3
Do not set the same station No. as that of the GOT.
(2) Target Device connection Configuration Setting
POINT
POINT
POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
(3) Routing setting
Up to 238 [Target Station Network No.]s can be set.
However, the same target station network number cannot be set twice or more (multiple times).
Therefore, the one that can access to other station from the request source host GOT is 238 kinds of [Target Station
Network No.]s.
Transient Transmission Group No.
(Use default value)
Online Program Change Permission/Protection Setting
Communication Data Code
Open Method Setting
Target Device Connection Configuration Setting
Refer to (2).
Item
Set value
Protocol
(Use default value)
Open system
MELSOFT connection (fixed)
Host station port No.
(Use default value)
Item
Range
Target Station network No.
1 to 239
Relay Station network No.
1 to 239
Item
Set value
Setting necessity at GOT
connection
Summary of Contents for GOT2000 Series
