5 - 90
5.4 PLC Side Setting
:Required :Set if necessary :Not required
*1
The default value of IP address is 192.168.1.250. Set the IP address corresponding to the system configuration.
POINT
POINT
POINT
When changing Ethernet parameter
After writing Ethernet parameters to the PLC CPU, turn the PLC CPU OFF then back ON again.
(2) Open settings
POINT
POINT
POINT
When connecting to multiple GOTs and peripheral devices
The number of protocols equivalent to that of the GOTs
and devices must be set.
■3.
[Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
(2) GOT Standard Ethernet Setting
Communication Data Code
(Use default value.)
Disable direct connection to MELSOFT
Do not respond to search for CPU on network
Item
Setting
Setting
(with GOT connected)
Protocol
TCP
Open System
MELSOFT connection
Item
Setting (Use default value.)
GOT Net No.
1
GOT Station
1
GOT Standard Ethernet Setting
192.168.3.18
GOT Communication Port No.
5019
Retry
3times
Startup Time
3sec
Timeout Time
3sec
Delay Time
0ms
Item
Setting (Use default value.)
GOT IP Address
192.168.3.18
Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
Peripheral Communication Port No.
5015
Transparent Port No.
5014
Item
Setting
Setting
(with GOT connected)
Summary of Contents for GOT2000 Series
