10 - 16
10.4 PLC Side Setting
■3.
Parameter settings (Connecting to MELSEC iQ-R series) of System configuration1
(Network Type: CC IE Control)
(1) [Module parameter] of GX Works3
(a)
Module parameter
: Necessary : As necessary : Not necessary
*1
Specify the same network No. as that of the GOT.
(b)
Network range assignment
: Necessary : As necessary : Not necessary
*1
Be sure to set it to perform the cyclic transmission.
POINT
POINT
POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
Item
Set value
Setting necessity at GOT connection
Station type
Control station (fixed)
Network No.
*1
1
Station number setting
1
Network range assignment
Refer to (b)
Item
Set value
Setting necessity at GOT connection
LB/LW setting
(1)
*1
LB
Station No.1
Start
0000H
End
00FFH
Station No.2
Start
0100H
End
01FFH
LW
Station No.1
Start
00000H
End
000FFH
Station No.2
Start
00100H
End
001FFH
LB/LW setting (2)
*1
No setting
LX/LY setting (1)
*1
No setting
LX/LY setting (2)
*1
No setting
Reserved station
(Use default value)
Pairing
Summary of Contents for GOT2000 Series
