12 - 80
12.4 PLC Side Setting
POINT
POINT
POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn the PLC CPU OFF then back ON again, or
reset the PLC CPU.
■3.
[Controller Setting] of GT Designer3
(1) Communication Settings of station No.1 (GOT)
(2) Communication Settings of station No.2 (GOT)
Item
Set value
Station No.
1: Station No.1
Transmission Rate
0: Online 156kbps
Mode
Ver.1: Remote net (Ver.1 mode)
Expanded Cyclic
Single (Use default value)
Number of stations occupied
1 Station
Input for Error Station
0: Clear
Retry
3times (Use default value)
Timeout Time
3sec (Use default value)
Delay Time
0ms (Use default value)
Transmission method
Cyclic
Item
Set value
Station No.
2: Station No.2
Transmission Rate
0: Online 156kbps
Mode
Ver.2: Remote net (Ver.2 mode)
Expanded Cyclic
Single (Use default value)
Number of stations occupied
1 Station
Input for Error Station
0: Clear
Retry
3times (Use default value)
Timeout Time
3sec (Use default value)
Delay Time
0ms (Use default value)
Transmission method
Cyclic
Summary of Contents for GOT2000 Series
