14.4 Device Range that Can Be Set
14 - 59
INVERTER
C
O
NNE
CTION
14
Write 1 to the bit of device SP121 that corresponds to the Reset command (WS11).
In this example, device SP121 must store 0800H.
Convert 0800H to a decimal value (2048), and then write 2048 to device SP121.
When using a WS device, [Alternate] of a bit switch cannot be used.
Use [Momentary], [Set], and [Reset] for bit switch actions.
The following shows correspondences between virtual inverter devices used in the GOT and data of the inverter.
Device SP121
b15
b7
b0
0 0 0 0 1 0 0 0 0 0 0 0 0 0 0 0
WS15: Not used
WS14: Not used
WS13: Not used
WS12: Not used
WS11: Reset (RES)
WS10: Selection of automatic restart after instantaneous power failure (CS)
WS9: Start self-holding selection (STOP)
WS8: JOG operation (JOG)
Summary of Contents for GOT2000 Series
