16 - 10
16.4 Robot controller Side Settings
(3) Ethernet setting
POINT
POINT
POINT
[Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠
16.3.1 Setting communication interface (Controller Setting)
■4.
Confirming communication state of CRnD-700
(1) When using the Command Prompt of Windows.
Execute a Ping command at the Command Prompt of Windows.
(a)
When normal communication
C:\>Ping 192.168.0.19
Reply from 192.168.0.19: bytes=32 time<1ms TTL=64
(b)
When abnormal communication
C:\>Ping 192.168.0.19
Request timed out.
(2) When abnormal communication
At abnormal communication, check the followings and execute the Ping command again.
• Cable connecting condition
• Parameter settings
• Operation state of the CRnD-700. (faulty or not)
• The IP address of the CRnD-700 specified for the Ping command.
Item
Set value
Ethernet setting No.1
Host
*
N/W No.
1
PLC No.
2
Unit Type
CRnD-700
IP address
192.168.0.19
Port No.
5001 (fixed)
Communication
UDP (fixed)
Summary of Contents for GOT2000 Series
