21 - 8
21.3 GOT Side Settings
21.3.2
General flow from system selection to drawing
System selection for using the multi-channel function is explained below.
Make selection and setting for the multi-channel function by following the order shown below.
Step 1.
System selection
Determine the connection type and the channel No. to be used.
➠
21.3.3 Determining the connection type and channel No. (System selection)
Step 2.
Interface selection
Determine the GOT side interface and communication units to be used for the multichannel function.
➠
21.3.4 Determining the GOT side interface (Interface selection)
Step 3.
Checking the unit installation position
Determine the communication unit installation position.
➠
1.3.7 Installing a unit on another unit (Checking the unit installation position)
Step 4.
Make settings for Communication Settings.
➠
21.3.5 Setting for communication settings
Step 5.
Confirm items to know before starting drawing.
➠
Summary of Contents for GOT2000 Series
