22 - 118
22.7 Personal Computer Side Setting
22.7.7
Accessing by the MT Developer
This section explains the procedure to set the FA transparent function of MT Developer with an example of connecting to
motion controller CPU (Q series).
Step 1.
Click [Communication]
[Communication Setting] in MT Developer.
Step 2.
Select [USB] in [Serial port].
Step 3.
Click [Detail].
Step 4.
Check-mark either of the following in [PLC side I/F setting of PLC module].
[via GOT(Bus) transparent mode]
[via GOT(direct coupled) transparent mode]
Step 5.
As necessary, select a CPU that is targeted by using the transparent function in [CPU].
Bus connection
Direct CPU connection
Summary of Contents for GOT2000 Series
