19 - 30
19.6 Setting of Serial Multi-Drop Connection Unit
19.6.2
Setting communication interface (Controller Setting)
Make the Serial Multi-Drop Connection Unit interface setting on [Communication with GT01-RS4-M] of GT Designer 3.
For the communication interface driver, set the same communication driver as the serial multi-drop connection.
For details on [Communication with GT01-RS4-M] of GT Designer3, refer to the manuals.
➠
GT Designer3 Version1 Screen design manual
■1.
Controller setting
Step 1.
Set the following to the driver for the connected equipment.
• Connection type dependent
The driver for connection with the GOT is fixed to the following one.
• Multi-drop(Host)
Step 2.
Perform the detailed settings for the driver.
➠ ■4.
Step 3.
Set [Use the system information of Multidrop] as necessary.
➠ ■2.
Setting the multi-drop system information function
Step 4.
Click the [Write] button when settings are completed.
Step 5.
If the [Communication with GT01-RS4-M] dialog box is closed, communication setting contents for GT01-
RS4-M does not remain.
• To maintain the communication setting contents, click
(export).
➠ ■3.
Exporting/Importing the communication setting contents
• To use communication setting contents which are saved previously, click
(import).
➠ ■3.
Summary of Contents for GOT2000 Series
