![background image](http://html.mh-extra.com/html/mitsubishi-electric/gt15v-75r1/gt15v-75r1_user-manual_239704016.webp)
8
(a) Construction of BNC connector and coaxial cable.
(b) Connecting the BNC connector with the coaxial cable.
Parts of the BNC connector
Construction of coaxial cable
1) Remove the outer sheath of the
coaxial cable in the specified
dimension as shown left.
2) Slip a nut, a washer, a gasket, and a
clamp through the coaxial cable as
shown left, and loosen the outer
conductor.
3) Cut off the insulating material and
internal conductive material in the
specified dimensions as shown left.
Cut off the outer conductor in the
same dimension as the taper part of
the clamp, and extend it over the
clamp.
4) Solder the contact to the tip of the
internal conductive material.
5) Insert the contact assembly of 4) into
the plug shell, and engage the plug
shell with the nut.
Clamp
Contact
Gasket
Washer
Nut
Plug shell
Outer sheath
Outer conductor
Insulating material
Internal conductive material
15mm
(0.59in.)
Remove the outer sheath.
Washer
Nut
Gasket
Clamp
3mm
(0.12in.)
6mm
(0.24in.)
Insulating material
Internal conductive
material
Clamp and
outer conductor
Soldering
Summary of Contents for GT15V-75R1
Page 25: ...17 MEMO ...