EN-6
Preparating your projector
Cables
Power supply parts
Remote control parts
Power cord
(two)
(246C483-10, 246C383-20)
Remote control
(290P130-10)
R03 (Size-AAA)
battery (two)
RS-232C cable
(246C508-10)
RGB cable for PC
(246C521-10)
S-video cable
(246C479-10)
Audio/Video cable
(246C478-10)
Others
• Lens cap (Attached to the
projector)
• User manual (871D423-30)
• Quick Start up (857D064-50)
Mini D-SUB
15-pin
Mini D-SUB
15-pin
D-SUB 9-pin
8-pin
1
2
3
Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed
in the package.
Important:
• The attached power cords are to be used exclusively for this product. Never use them for other products.
Inserting the batteries into the remote
control
1. Remove the rear lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
• If the battery is inserted from the (+) side first,
inserting the (-) side is difficult because the coil spring
end hits on the battery side. If the battery is forced to
insert in this way, the outer label of the battery may
get ripped and it may cause a short-circuit and heat-
ing.
3. Attach the rear lid.
Important:
• Use two size-AAA batteries (R03).
• Replace the two batteries with new ones when the
remote control is slow to operate.
CAUTION
• Use of a battery of wrong type may cause explosion.
• Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
• Dispose of used batteries according to your local regulations.
• Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fire.
• Be sure to handle the battery according to the instructions.
• Load the battery with its positive (+) and negative (-) sides correctly oriented as indicated on the remote
control.
• Keep batteries out of reach of children and pets.
• Remove the battery, if the remote control is not used for a long time.
• Do not combine a new battery with an old one.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes
in contact with your eyes, rinse them with water and then consult your doctor.
http://www.pureglare.com.au
