EN-31
ENGLISH
DISPLAY INPUT
LOCK
UNLOCK
OK
OK
PASSWORD
CONFIRM
O K
CANCEL
DISPLAY INPUT
LOCK
UNLOCK
OK
OK
PASSWORD
O K
CANCEL
Password function
This projector is equipped with the password function
that is designed for prevention of theft and wrong op-
eration by children and restriction on operation by other
than specified users. The password function has two
modes as follows.
DISPLAY INPUT ...........When the projector is turned
on, the startup screen (or splash screen) will appear
and stay on the screen until the password is entered.
When the password is entered, the startup screen
will switch to the regular operation screen.
MENU ACCESS ............All the buttons except for the
POWER button on the projector are disabled. (The
buttons on the remote control are enabled.) You can
use this mode as a measure of prevention of wrong
operation by children and restriction on operation by
other than specified users.
To enable the password function:
1. Display the FEATURE menu.
2. Press the
or
button to select PASSWORD
FUNCTION.
3. Press the
button to change the mode among DIS-
PLAY INPUT and MENU ACCESS.
• When the password has already been set, the
mode won’t be changed. In such cases, press the
ENTER button to cancel the password function
and try again.
4. Press the ENTER button.
• The screen for setting the password function will
appear.
5. Press the ENTER button.
• The screen for entering a password will appear.
6. Press the
or
button to select a number from 0
to 9.
7. Press the
button.
• You can set the next digit.
8. Repeat steps 6 and 7 to set a four-digit password.
9. Enter the password again for confirmation using the
same steps.
10. Select OK, and press the ENTER button.
• If the entered passwords don’t match, an error
message will appear.
• To cancel the procedure, select CANCEL and
press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
To cancel the password function:
1. Display the FEATURE menu.
2. Press the
or
button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
• The screen for canceling the password function
will appear.
4. Press the ENTER button.
• The screen for entering the password will
appear.
5. Press the
or
button to select a number from 0
to 9.
6. Press the
button.
• You can set the next digit.
7. Repeat steps 5 and 6 to enter the four-digit
password.
8. Press the
button, select OK, and press the
ENTER button.
• If you enter a wrong password, an error message
will appear.
• To cancel the procedure, press the
button,
select CANCEL, and press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
Important:
• If you forget your password, hold down the MENU
and ENTER buttons on the control panel at the
same time about three seconds to cancel the
password function.
Kensington Lock
This projector has a Kensington Security Standard
connector for use with Kensington MicroSaver Security
System. Refer to the information that came with the
Kensington System for instructions on how to use it
to secure the projector. Please contact Kensington
Technology Group below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone: +1- (650)572-2700
Fax: +1- (650)572-9675
Advanced features
