3
Removal of components
Removing the front panel
①
Remove the screws at each side of the front panel.
②
Pull down the front panel at this side.
③
Push the spring inward and remove from the slot at each side.
④
Draw out the front panel in the direction of the arrow.
●
The panel is suspended with wires that do not drop off.
Removing the maintenance cover
Turn the stopper 90 degrees and remove the maintenance cover.
2
Removing the air filters
(at outside air intake and return air sides)
●
Remove air filters from the Lossnay core.
Cleaning the air filter
Lightly tap with hand or use a vacuum cleaner to
remove dust.
●
When they are soiled heavily, wash them by pushing down
repeatedly in water or warm water (40
℃
or lower) containing
neutral detergent. Dry them completely.
●
Never attempt to use hot water or squeeze to wash. (Air filters
could be deformed and become unable to maintain the designed
capacity.)
●
Be sure to install the air filters.
●
Care must be taken not to damage the surfaces of Lossnay core
when removing or installing the air filters.
Cleaning the Lossnay core
Remove dirt or dust from the surface using a vacuum
cleaner. Lightly contact the nozzle of cleaner with
long brush to make clean.
●
Do not splash the Lossnay core with water, hot water, chemicals,
volatile solvent, or others.
●
Refrain from pressing hard on the Lossnay core with steel wire,
screw driver, hard nozzle of cleaner, or the likes.
1
Request
Request
English
Prohibition of
washing with
water
