M70V Series Connection Manual
2.1 Environment Conditions
13
(Note 1) "Short term" means within one month.
(Note 2) For the current value of the I/O circuit, calculate with the number of points used and load.
(Note 3) For the heating value of the I/O circuit, calculate with the number of points used.
(Note 4) Allows only the amount to be consumed by control circuit.
(Note 5) Differs according to the number of machine input operation points and the load and number of points
connected to the machine output. The maximum value applies when all points are ON.
(Note 6) MITSUBISHI CNC M70V Series, which is an open equipment, must be installed within a sealed metal control
panel.
(Note 7) FCU7-KB926 does not need 24VDC power supply input.
Item
Unit name
Remote I/O unit
Type
FCUA-DX10x
FCUA-DX11x
FCUA-DX12x
FCUA-DX14x
General
Specificati
ons
Ambient
temperature
During
operation
0 to 55C
°
During
storage
-20 to 60C
°
Ambient
humidity
Long term
10 to 75% RH (with no dew condensation)
Short
term
10 to 95% RH (with no dew condensation) (Note 1)
Vibration resistance
4.9m/s
2
or less (during operation)
Shock resistance
29.4m/s
2
or less (during operation)
Working atmosphere
No corrosive gases or dust
Required
power
specificatio
ns
Input power voltage
24VDC
±
5% Ripple noise 200mV (P-P)
Power capacity
24V 0.7A (Note 4)
24V 1.5A (Note 4)
24V 0.7A (Note 4)
Instantaneous stop
tolerance time
-
Others
Heating value
(max.)
25W (Note 5)
30W (Note 5)
30W (Note 5)
Mass
0.5kg
0.6kg
0.6kg
0.6kg
Summary of Contents for M70V Series
