Automatic cleaning is not performed while the Clean Dust Box lamp is lit.
Empty the dust box and then reset it. P.14
11
Operation
A cleaning mechanism inside the main unit cleans the pre-filter automatically.
The pre-filter is cleaned automatically in the following cases.
l
When the Auto Cleaning switch
is pressed while the operation
On/Off switch is ON
→
Cleaning is performed for
approximately 2 minute 40 seconds
(two rotations of the pre-filter)
Press
l
When the total operation time exceeds a certain time
while the operation On/Off switch is ON
Approximately 24 hours for “Turbo” manual operation and
approximately 120 hours for “Silent” manual operation
→
Cleaning is performed for approximately 2 minute 40
seconds (two rotations of the pre-filter)
l
The Auto Cleaning lamp lights up.
l
The air volume switches
to “Low” and automatic
cleaning starts.
l
When automatic cleaning
ends, operation resumes in
the previous operation mode.
l
The Auto Cleaning lamp goes
out.
To stop automatic cleaning part way through the
process
, press the Auto Cleaning switch.
Alternatively, press the Auto switch or Manual
switch.
l
Dust is collected into the dust box.
If the Clean Dust Box lamp lights up, empty the dust box.
P.14
•
The Clean Dust Box lamp only serves as a rough guide.
The amount of dust that collects into the dust box will differ depending on the operating environment.
When the air purifier is used in a place with a lot of dust and other dirt, check the dust box and empty it often.
l
Cigarette tar and minute dust particles adhered to the pre-filter will not be removed.
If such dirt bothers you, wash the pre-filter in water.
P.12-13
l
When the cleaning brush becomes dirty, removal of dirt from the pre-filter will become difficult.
Clean the cleaning brush if it is dirty.
P.13
The pre-filter rotates and passes through the dust box
The dirt on the pre-filter is collected with the cleaning brush
and accumulates on the scraper plate.
Dust box
Pre-filter
Cleaning brush
Pre-filter
Scraper plate
Dust box
Pull out
The dust accumulated on the scraper plate may gather together into a long belt-like shape that does not drop into
the dust box. If the dust on the pre-filter is removed, the cleaning mechanism is working properly.
How the Cleaning Mechanism Works
Automatic Cleaning
(Pre-filter)
en_ma-a85r-a_cs55.indd 11
2021/10/20 13:11:17
