Odor monitor
The state of air contamination from
cigarette odor and other odors is
detected by the odor sensor and
then indicated.
PM2.5 monitor
The state of contamination from PM2.5 and
other small particles is detected by the PM2.5
Sensor and then indicated.
Dust monitor
The state of air contamination from pollen, dead
bodies of mites, and other large particles is
detected by the PM2.5 Sensor and then indicated.
PM2.5 Sensor
<Size of dirt particles>
Viruses
Dust, particles harmful to the lungs
Feces and dead bodies of mites
Cigarette smoke particles
PM2.5 monitor
Dust monitor
Pollen
Mainly particles of 2.5 μm or less
Mainly particles greater than 1 μm
0.01
0.1
1
0.5
2.5
10
100 (μm)
PM2.5
This optical sensor detects the number
of particles. The monitor indications
are divided into “PM2.5” and “Dust”
according to the size of the particles.
* This unit does not detect particles
smaller than 0.5 μm.
Adjusting the Sensitivity of the
PM2.5 Sensor
P.10
7
Before Use
Control Panel
Automatic Cleaning
P.11
Operation
P.9
Operation
P.9
Operation
P.9
Operating the Louvre
P.10
l
Auto Cleaning switch
Turns ON/OFF automatic cleaning.
l
Auto Cleaning lamp (yellow)
Lights during automatic cleaning.
l
Manual switch
Changes the air volume.
l
Air volume lamps (green)
Indicate the air volume during operation.
l
Operation On/Off
switch
Turns ON/OFF operation.
l
Auto switch
Changes the operation.
l
Operation mode lamps (green)
Indicate the operation mode.
l
Smart Search switch
Turns the louvre swing OFF/ON.
l
Smart Search lamp (green)
Lights when Smart Search is ON.
l
Clean Dust Box lamp (red)
When it becomes time to empty the dust
box, this lamp lights to notify you.
P.14
l
Replace Filter lamp (red)
When it becomes time to replace the HEPA
filter, this lamp lights to notify you.
P.16
l
Reset button
{
Cancels the Clean Dust Box lamp.
P.14
{
Cancels the Replace Filter lamp.
P.16
l
Triple clean monitors (green/yellow/orange)
Orange
Yellow
Green
Yellow
Green
Green
Air is
clean
Air is
contaminated
The state of air contamination
detected with the odor sensor and
PM2.5 Sensor is indicated by lamps
lighting in three steps.
Odor sensor
This semiconducting sensor
detects odors and other gases.
It also responds to wind from air
conditioners, electric fans, and
other appliances, odorless gases,
and perfumes.
en_ma-a85r-a_cs55.indd 7
2021/10/20 13:11:13
