13 DIAGNOSING BOARD STATUS
13.2 Diagnosing CC-Link IE Field Network
119
13
Selecting the diagnostics target
The following explains the target selection for CC-Link IE Field Network diagnostics.
The entire network status can be checked by connecting CC IE Field Utility to a master station. However, when a local station
status cannot be checked because of a failure such as a cable disconnection, connect the utility to a local station directly.
Selecting diagnostics target board
When two or more CC-Link IE Field Network boards are installed to a personal computer, the "Select Diagnostics Destination"
screen as shown below is displayed before starting diagnostics. Select a board to be diagnosed and click the [OK] button.
Changing diagnostics target board
To change a board to be diagnosed during the CC-Link IE Field Network diagnostics, click the [Change Board] button on the
"CC IE Field Diagnostics" screen. The "Board Change" screen is displayed.
Select a board to be diagnosed, and click the [OK] button.
Displaying diagnostics screen
The following explains the diagnostics screen of CC-Link IE Field Network.
Window
[Diagnostics]
[CC IE Field Diagnostics]
Select Diagnostics
Destination
Network Status
Network configuration
Operation Test
Information
Confirmation/Set
Monitor Status
Disconnected station
status monitor
Selected Station Communication
Status Monitor
Summary of Contents for MELSEC Q80BD-J71GF11-T2
