19
Operating
Internal Drying Operation
The inside of the unit can be dried to suppress mildew growth on the cooler.
On days the dehumidifi er is used, internal drying is recommended.
Automatic operation
To activate internal cleaning after every use.
Manual operation
Press the
while the unit is OFF.
Press
while the unit is ON
Press
while the unit is OFF
Internal cleaning operation standby
(The MILDEW GUARD ELITE lamp lights)
The operation ends
The internal cleaning operation starts
The MILDEW GUARD ELITE lamp fl ashes,
the current humidity indicator turns off, and
the louvre stops in the vertical position
Internal cleaning operation
The internal cleaning operation ends
The MILDEW GUARD ELITE lamp turns off
and the louvre closes
The internal cleaning operation starts
The MILDEW GUARD ELITE lamp fl ashes
and the louvre stops in the vertical position
Internal cleaning operation
The internal cleaning operation ends
The MILDEW GUARD ELITE lamp turns off
and the louvre closes
When you want to deactivate automatic operation
Press the MILDEW GUARD ELITE switch
while the unit is ON
(The MILDEW GUARD ELITE lamp goes out)
When you want to stop the operation
When you want to end the operation
partway through:
Press the MILDEW GUARD ELITE switch.
(The MILDEW GUARD ELITE lamp turns off)
When you want to switch to another
operation:
Press the POWER switch.
Information
Connecting/disconnecting the power plug deactivates automatic operation.
This function does not remove existing mildew. Also, aborting internal cleaning operation may cause the benefi ts to
diminish.
Do not close the louvres during mildew guard elite operation as this causes noise.
The moisture expelled from inside the unit may cause the humidity level of the room to rise.
The air leaving the unit may appear white depending on the humidity or temperature of the room.
The moisture expelled from inside the unit may smell due to odorants* that were not caught by the fi lter dissolving in the water.
* The silver ion fi lter is mainly for absorbing ammonia.
The OFF timer cannot be set during mildew guard elite operation.
Details on mildew guard elite operation
This operation takes approximately one hour. However, when
the room temperature is below 1°C, drying time is shortened
to protect the compressor.
OFF
Airfl ow
Drying is performed
by blowing wind
Approx. 30min.
Mildew guard elite operation
(approx. one hour.)
Regular
Operation
Unit stops
automatically
Airfl ow
Drying is performed
by blowing wind
Approx. 10min.
Airfl ow stops; compressor activated
Drying is performed by heating
the heat exchanger
Approx. 20min.
(Varies according to the room temperature)
Operating
sound
Compressor
stops
e̲mj̲15bx̲a1.indb 19
e̲mj̲15bx̲a1.indb 19
2008/08/19 17:58:48
2008/08/19 17:58:48
