23
Silver Ion Filter (Soak in Water)
Soaking the silver ion fi lter in water
enables you to remove fi ne dust and odour from the silver ion fi lter.
Troubleshooting
Remove any dust from the white net
surface with the nozzle of a vacuum
cleaner.
Do not use a nozzle with a brush. This may
damage the fi lter.
Remove the fi lter cover
1
Removing the fi lter, see P22
Remove the silver ion fi lter
from the fi lter cover, and then
clean the fi lter.
2
Silver ion fi lter
Filter cover
Soak the silver ion fi lter in
water.
3
Soak in cool to
lukewarm water for
about 30 minutes.
Do not use detergent or hot water. Also,
do not use a brush or the like to scrub the
fi lter or rub the fi lter while soaking. This may
damage the fi lter.
Dry the silver ion fi lter well
4
Once Every Three Months
Dry the fi lter on an
even surface in the
shade.
Preparation
Press the POWER switch to turn off the
power, wait until the blower fan stops rotating
(approximately 2 minutes) before unplugging the
power cord.
Any yellow or dark stains may remain on the
fi lter, but should not affect performance.
The fi lter can be soaked for a total of eight
times. After that, replace with a new fi lter.
Do not hang with pegs or the like. This may
damage the fi lter.
Do not use the fi lter while wet.
Set the silver ion fi lter into
the fi lter cover
5
Setting the fi lter, see P22
Set the fi lter cover.
6
Setting the fi lter, see P22
e̲mj̲15bx̲a1.indb 23
e̲mj̲15bx̲a1.indb 23
2008/08/19 17:58:49
2008/08/19 17:58:49