25
E
Tr
oub
leshooting
Symptom
Cause/Remedy
¡
Check to see if the unit is on a slope or uneven surface.
➝
Move to a sturdy even surface.
¡
Check to see if the pre-filter is clogged.
→
Clean according to the maintenance procedures
¡
Operating the unit in small rooms or in tight spaces sometimes
causes the sound to reverberate.
➝
Place a mat underneath the unit.
The unit
makes
noises
The operating
noise is
loud/reverberates
The operating
sound suddenly
increases in volume
The wind sound
changes in volume
The unit
produces a
simmering sound
The unit buzzes
intermittently (or
the compressor
does not
activate)
The unit
produces
an odour
When first
used
During
internal
drying
¡
The sound increases when the compressor activates (3
minutes after turning on the unit or during Easy dehumidifier
and Automatic modes).
¡
The volume of the sound differs depending on the angle of the louvre.
¡
This is the sound of the refrigerant.
The sound can be heard while the refrigerant stabilizes after
the unit turns on, changes modes, or stops.
¡
This is the sound of the compressor.
In modes that monitor the humidity level, the compressor operates
intermittently causing the sound to be heard occasionally.
The compressor does not activate after turning the unit off, or
for 3 minutes after plugging the unit into a power socket. (This
is to protect the compressor from damage.)
¡
The heat converter heats rapidly causing an odour. This is not
a malfunction.
¡
The moisture expelled from inside the unit may smell due to
odorants* that were not caught by the filter dissolving in the
water. This is not a malfunction.
Digital display
Cause/Remedy
appears
¡
Error message (Humidity indicator)
appears
-
appears
¡
Check to see if the power cord is plugged into the power
socket properly.
➝
Plug the power cord into the power socket properly.
¡
Check to see if anything is blocking the air outlet.
➝
Remove the obstruction, and plug the power cord into the
power socket again.
¡
Check to see if the pre-filter is clogged.
➝
Clean according to the maintenance procedures.
¡
Malfunction
➝
Unplug the power cord, take note of the error message,
and contact the place of purchase.
If the symptoms persist even after following the prescribed remedies, or the error message does not
disappear, unplug the power cord, and contact the place of purchase.
6
22
3
16
12
11
5·11
22
e_mj_e20txh(20_26)_e33.qx 10/17/03 8:40 PM Page 25
