Mitsubishi Electric MR-260R, Operating Instructions Manual

3. Ice making

  Pour water into each of the sections of the ice tray up to the water line. Insert the tray completely into the ice tray

holder. The ice cubes will not separate easily from the ice tray if you add too much water.

  Once the ice cubes are made, turn the lever until the ice cubes fall into the ice cube storage box.

  The ice cube storage box will break if you attempt to make ice directly in the ice cube storage box.

  Remove the lid and chilled case as in the figure and proceed with cleaning.

  Comes off by pulling out the case, open the lid, then pull out while holding the right-hand side with the lid moved

towards the left-hand side. (Fig. 1)

  Comes off by pulling the case out all the way, then pulling out while holding and lifting the edge of the case upwards.

  Comes off by pulling the case out all the way, then pulling out while holding and lifting the edge of the case upwards.

 (Fig. 

2)

Fig. 1

Fig. 2

Lid

Chilled case

Opens by pulling out the case.

4. Slide chilled compartment

This slide chilled compartment is cooled down to about 0

o

C to preserve freshness of foods stored for a long time.

CAUTION:

Before closing the refrigerator compartment door, make sure that the chilled case is pushed in all the way
(the lid is closed correctly).

  Lift the chilled tray up from the projection at the rear center of the tray.

Install the chilled tray with the projection at the rear center of the chilled case.

Do not put any items under the chilled tray. Cool air must flow under the tray.

4