1. How to remove the drain pan
Pull the refrigerator away from the walls.
Remove the drain pan as shown.
When removing the drain pan, pull up on the drain pan at a slight angle so it does not contact the drainpipe.
To install, insert the drain pan completely so the drainpipe is located above the drain pan.
(Failure to insert the drain pan completely can lead to water leaks, noise, and vibration.)
2. How to replace the room light
Important: Unplug the power cord. Failure to unplug the power cord may cause an electric shock.
Pull out the room light cover toward you by pressing the lower convex part up to remove the room light cover.
Remove the room light at the right of the temperature control inside of the refrigerator compartment.
Purchase a room light of 240V/15W (capE-12) from a store.
When performing maintenance, make absolutely sure that the power plug is first disconnected from the power outlet.
Dip a soft cloth into cold or lukewarm water, wring it out well and wipe.
If you do not clean the door gasket (especially the lower part) when it is dirty, the gasket will get easily damaged.
Therefore, keep it clean at all times.
Do not clean with cleanser, acids, benzine, thinner, boiling water, soap powder, chemical cloths or neutral detergents.
These will damage the paint finish and material of your refrigerator.
The drain pan gets dirty very easily and if it is not cleaned regularly, bad odours will be produced. Get into the habit
of cleaning this pan regularly.
5. Maintenance
CAUTION
Do not apply water directly to the refrigerator.
This may result in a breakdown, power leakage or fire.
LOW
MID
HI
REFRIGERATOR CONTROL
Summary of Contents for MR-260R
Page 1: ...Refrigerator Freezers OPERATING INSTRUCTIONS MODEL MR 260R ...
Page 2: ......
Page 11: ......
