14
・
Minimise opening/closing of doors and avoid putting in more food.
When not in use for a long time (Remove the power plug)
Clean the auto ice-maker.
Clean the interior after unplugging the refrigerator.
Keep the door open for 2 - 3 days to let it get dry.
➡
Page 10, 13
※
If not allowed to dry properly, mould and odors can occur, or refrigerant (gas)
may leak due to corrosion of the cooling unit.
When transporting
Empty any water or ice from the water supply tank and ice-making tray.
Wear protective gear (gloves).
Remove the toe grille, and then rotate and raise the adjustable leg.
Remove the power plug.
Lay towels under the drainage port and the lower rear edge of
the refrigerator and position a container or tray with a height of
about 3 cm. on the towels to collect the water.
➡
Page 10
➡
Page 5
※
※
※
The towels prevent floor damage, and water from being spilled on the floor.
Because the refrigerator is heavy, the work must be performed by at least 2 people.
The work must not be performed by small children or people who are not
capable of doing heavy work. Ask a specialist transportation company.
Tilt the refrigerator slowly to the rear by about 30 degrees, and drain
the water from the evaporation tray via the drainage port on the
lower rear side. (The evaporation tray is not visible from the outside.)
2 or more people should hold the hand-holds on the lower inside of the
front and the upper side of the rear, and carry the refrigerator slowly.
・
Do not lay or load on its side (it will cause damage to the compressor.)
Water discharge outlet
Front side - lower
section inner edge
Back side - upper
section handle
・
・
The frost may melt, and the water may spill from the cooler in back of freezer compartment during transport.
It may take 1 day from unplugging until the frost melts.
When it will take time to move, such as during relocation
When moving the unit / when changing the direction of the unit
Because a flammable refrigerant (gas) is used, there is the danger
of igniting or explosion.
Do not damage the refrigerant circuit (piping) of the
refrigerator; do not drive in screws.
Do not do
Remove the toe grille, and then rotate and raise the adjustable leg.
When changing the direction of the unit, please use caster wheels or place a protective cloth under the back legs.
Move in a forward or backward direction.
Page 5
➡
※
If moved other than in a forward or backward direction, there’s a risk of damaging the floor.
What to do in these situations
What to do in these situations
When there’s a power failure
