From installing to running your refrigerator
From installing to running your refrigerator
Where to install your fridge
●
Install in a place where there is no direct
sunlight or heat, and with good ventilation.
This protects against a decrease in cooling power
and saves on electricity bills.
●
Install in a place with low humidity.
This prevents rust, electric shock or fires from
occurring.
●
Install on a solid and level floor.
This prevents vibrations, noise, and partially
open doors or doors left ajar.
Prevent changes or discolouring by its
mass or heat.
※
If the refrigerator adjustment feet sink easily
into the flooring material, please lay a strong
board on top of the flooring.
●
Install away from other appliances.
This prevents noise or image disturbances to
the television, etc.
●
Leave a space of more than 2 cm to
the left and right, more than 10 cm
from the ceiling, and more than 5 cm
from the back.
This is to allow heat to escape from the top,
back and sides.
※
If refrigerator is too close to the wall,
it will cause noise.
Please take care to remove the dust within
the gap.
Installation
Do not install in an outdoor area
where water can get on the unit
or where there is a lot of moisture.
Due to insulation failure, it may
cause an electric shock or fire.
Do not get wet
Allow some space around
the refrigerator.
If the refrigerant (gas) leaks, it can
remain in the area and there is a risk
that it may cause a fire or explosion.
Always follow
instructions
Turning on the power
●
Turn on the power of the refrigerator as soon as possible.
The refrigerator will not be damaged even if you turn on the power
immediately after the installation.
Use a dedicated outlet for the
power supply that meets the
rating specified on the rating label.
To get the refrigerator
cooled down faster, plug
it in right after installing.
Lower back section
2 cm. or more
10 cm. or more
Earth screw connection
4
5 cm. or more
Remove the energy label carefully. A glue residue may remain,
particularly if the label has been in place for a long period of time.
Apply either Eucalyptus or Tea Tree oil directly on any residue.
Do not allow the oil to run or drip onto plastic parts as it may
cause the plastic to degrade and potentially crack over time.
Allow the oil to sit for approximately 1-2 minutes, or until the
glue residue has softened.
Wipe off with a damp cloth.
If any residue remains, repeat the above process.
Rinse with clear water.
Dry thoroughly.
●
●
●
●
●
●
●
●
How to remove the energy label
