10
(Control panel in the
refrigerator compartment)
Water supply tank
Put the water supply
tank back in place.
Take out the freezing case (upper) and the ice storage box.
And discard water or ice.
●
Do not put the food items when making ice.
Please gently close the door of freezing compartment.
Ice cube may get dirty.
Do not insert water over full water mark in water supply tank.
Water channel in the ice tray may freeze, ice cube may
connect together, and convex may come out, if insert
water over the mark or pour water by kettle.
●
Please do not store anything above the level on the side
of the freezing case (upper).
(The door may half-open and it may cause failure/damage).
●
Do not insert any drinks such as hot water, juice, tea, soft drink, etc.
other than water in water supply tank (heatproof temperature 60
o
C).
It may cause failure.
●
Ice-making will stop when the amount of storage ice is given quantity.
Ice cube will flat when it thick some, please insert ice server
horizontally in front side of ice storage corner as the left figure.
●
●
Maximum level for
storing foods
Ice tray
Detection Lever
(Detects volume
of ice stored.)
Ice server
Door
Ice storage box
Freezing Case (upper)
Take out the water supply tank,
close the freezer door.
●
Ice made with water containing a lot of mineral substances
such as mineral water, can cause to ice to form with a white
sediment (white crystals). These are only mineral substances
that have become crystallized. It is harmless.
●
If ice is stored for a long period of time, the
ice cubes may cling together or become smaller.
(This is known as the phenomenon of sublimation.)
About the ice
●
Ice-making may take longer with frequent
opening/closing of the door, or depending
on the ambient temperature.
It may cause injuries.
Please pay enough attention
when crush the ice which stuck
in ice storage corner.
Caution
To stop
ice-making
Press button
when the ice-making
stop light (red) is off.
The ice-making stop
light (red) will turn on.
Press button
when the ice-making
stop light (red) is on.
The ice-making stop
light (red) will
turn off.
When you will not make ice for a long time
※
Also do this when moving or transporting unit.
Empty the ice-making tray by taking out the ice or by forcing water to go into the ice storage box.
Press for about 5 seconds.
(at temperature adjustment panel,
inner back of refrigerator compartment.) - (Press until it makes a beeping sound.)
●
●
The Stop ICE MAKER OFF light (red) will blink for about 1 minute. (It drops down the ice-making tray’s water or ice.)
When the light stops blinking, it will return to the previous indication.
Stop making ice.
●
If the ICE MAKER OFF light (red) is off, press and check to confirm
that the ICE MAKER OFF light is on.
Wash with water, dry, and put back in place: the water supply tank (water supply pump,
pipe, water filter), freezing case (upper), ice storage box and the noise reduction mat.
➡
Page 13
To restart ice-making, press to cancel the ICE MAKER OFF function.
(The ICE MAKER OFF light will go off.)
To restart
ice-making
Red light
Press
Freezing case
(upper)
●
The red light is on when
ice-making stopped.
Keep ice at an even level
The ice cubes connected
Protrusion on the ice
Please note
