1. FUNCTIONS AND CONFIGURATION
1 - 32
(c) MR-J4-500B4(-RJ)
POINT
The servo amplifier is shown without the front cover. For removal of the front
cover, refer to section 1.7.2.
(1)
(3)
(Note)
(2)
(4)
(5)
(6)
(7)
The broken line area is the same as
MR-J4-200B4(-RJ) or less.
No. Name/Application
Detailed
explanation
(1)
Control circuit terminal block (TE2)
Used to connect the control circuit power supply.
Section 3.1
Section 3.3
(2)
Main circuit terminal block (TE1)
Used to connect the input power supply,
regenerative option, and servo motor.
(3)
Battery holder
Install the battery for absolute position data
backup.
Section 12.2
(4)
Rating plate
Section 1.6
(5)
Power factor improving reactor terminal block
(TE3)
Used to connect a power factor improving DC
reactor.
Section 3.1
Section 3.3
(6)
Charge lamp
When the main circuit is charged, this will light.
While this lamp is lit, do not reconnect the cables.
(7)
Protective earth (PE) terminal
Section 3.1
Section 3.3
Note. Lines for slots around the battery holder are omitted from the illustration.
Summary of Contents for MR-J4-100B(-RJ)
