Mitsubishi Electric MR-L72EN, Operating Instructions Manual

7

Before use

Operation

Cleaning

When in 

trouble

Prepare for earthquakes.

Strong belts

WARNING

Thread 2 strong belts through the hand-holds on the top rear
of the refrigerator and anchor them to a strong location,
such as wall or post.

The refrigerator may tip

over and cause injury.

The operation noise gets 

louder immediately after 

installation.

Immediately after instillation, when: 

the weather is hot, the doors are 

frequently opened or closed, or 

any similar situation; the operation 

noise will get louder because the 

refrigerator will switch to high-speed 

operation to cool with high power.

Although R600a refrigerants are combustible, the refrigerant

circuit is hermetically sealed and normally leaks will not occur.

WARNING

Should the refrigerant circuit be damaged:

1. Do not use flames or electrical appliances nearby.
2. Open the windows to fully ventilate the room.

Then, contact the retail store where you purchased the refrigerator.

Do not damage the refrigerant 

circuit (pipes) or drive screws into it.

Preventing ajar doors

Adjusting a tilted door or unevenness

 Installing the support cover

While the freezer door is open

Insert the support cover horizontally 
and fully, until it makes contact with 
the rear side.

Support cover

The support cover is stored inside

the refrigerator compartment

at shipment.

4

Adjustment and anchoring

Turn the adjustable supports until they touch the floor and

the front casters are raised from the floor.

3

Adjust the supports to 

make the refrigerator 

level.

If the front of the 

refrigerator is slightly 

raised, the doors are 

easier to close.

Readjust the adjustable supports as 

shown in the figures below.

The right door tilts down

Raise the right side

Right  Left

The left door tilts down

The support covers are designed for the
left and right adjustable supports respectively.

Raise the left side

If the installation 

location is not level or 

the supports sink after 

a few days due to the 

weight of the food, 

the doors may appear 

tilted.

Readjust the supports.

Adjustable

   support 

 Flat-blade

screwdriver 

Caster

Insert the blade of the screwdriver

Turn the adjustable supports 

in the arrow direction until 

they touch the floor.

Support cover

(To prevent vibration, noise, movement, and ajar doors)

Bottom front of refrigerator

If the supports are not 

adjusted properly, the 

refrigerator may move 

and cause injury.

CAUTION

Support cover

Adjustable

support

If the door is still tilted after adjustment of the supports

When installing the refrigerator in
the corner of a room, one of the
rear supports may sink, causing the
refrigerator to tilt. If this happens,
use a caster support or strong board
for adjustment. (Normally, use a
board with a thickness of about 2 to 3 mm.)

Rear support

Caster support

or strong board