61
Service
Supplementary Information (Unit Function Setting)
(For setting, refer to OUTDOOR UNIT’S SERVICE MANUAL.)
1) Vane setting (Function setting mode11)
Model
Setting No.
: Initial setting
Setting
PLA-BA(2)(3)
1
Downward position than the standard (less smudging setting)
2
Standard position
3
Upward position than the standard (less draft setting) *
PCA-KAQ
1
No vane function
2
Standard position
3
Upward position than the standard (less draft setting) *
*Be careful of the smudge on ceiling.
2) Vane differential setting in heating mode (cold wind prevention) (Function setting mode14)
When piping temperature (TH5) becomes low during heating operation, the up / down vane is set to horizontal direction for
less draft setting.
In this vane differential setting, the conditions of piping temperature to change airflow setting of horizontal and setting shown
below can be adjusted finely.
Setting airflow
Horizontal airflow
Piping temperature (TH5) (˚C)
28˚C
32˚C
38˚C
Setting 1 (low) • • • 24˚C
Setting 2 (standard) • • • 28˚C
Setting 3 (high) • • • 32
Meaning of "Function setting"
Mode02 : indoor temperature detecting
No
indoor temperature (ta)
No.1 Average data of the sen-
sor on all the indoor units
Intial
setting ta = (A+B) / 2
ta = (A+B) / 2
ta = A
ta = A
No.2
The data of the sensor
on the indoor unit that
connected with remote
controller
ta = A
ta = B
ta = A
ta = A
No.3 The data of the sensor on
main remote controller.
ta = C
ta = C
ta = C
ta = C
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
OUTDOOR
INDOOR
REMOTE
(MAIN)
*Can be set only when a wired remote controller is used. This function cannot be set for floor type models.
When using 2 remote controllers (two-remote controller operation), the remote controller with built-in sensor must be set as a
main remote controller.
Summary of Contents for Mr.Slim PAR-30MAA
