Before Use
Follow the
instructions
Turn the adjustable supports
in the direction of the arrow
until they touch the floor.
*1
:
The board thickness should be around 2 - 3 mm.
Preparing for Earthquakes
It is recommended that you
secure the refrigerator to a
strong location such as wall
or post.
In some cases, the weight of the refrigerator will cause the floor to
sink after several days, causing the door to tilt down. If this occurs,
adjust the tilt again using the adjustable supports.
(To prevent vibration, noise, movement,
and ajar or tilting doors)
Adjust the adjustable supports so the refrigerator is level.
When the right door tilts down
Turn the right adjustable support
in the direction of the arrow.
If the door is still tilted after
adjusting the adjustable support,
place a strong board*
1
under the
adjustable support on the left
rear side to make it level.
Turn the left adjustable support
in the direction of the arrow.
If the door is still tilted after
adjusting the adjustable support,
place a strong board*
1
under the
adjustable support on the right
rear side to make it level.
When the left door tilts down
Adjustment and Anchoring
3
Turn the adjustable support in the
direction of the arrow to lower the
refrigerator, and insert a felt sheet
between the support and the floor.
Insert the tool as far as it goes into
the indentation of the adjustable
support.
Turn the tool to adjust the tilt of
the refrigerator.
When the adjustable support is difficult to turn
Use the provided adjustable support tool kit. This took kit is placed inside the refrigerator compartment at the time of shipment.
Anchor the refrigerator so it does not move.
* The figure shows the left support. The right support is the same.
Felt
Sheet
Adjustable
Support
(Bottom Front)
Adjustable
Support Tool
Indentation
Anchor the refrigerator to
a strong and level floor by
adjusting the adjustable
supports.
Do not use any tools
other than the designated
adjustable support tools.
There is a risk that the
refrigerator may move and cause
injury or damage to the floor.
Bottom front of refrigerator
Adjustable
Support
Caster Wheel
After adjustment, install the adjustable support covers.
(The adjustable support covers are placed inside the
refrigerator compartment at the time of shipment.)
Adjustable
Support
Cover
Adjustable
Support
Caster Wheel
If the front of the refrigerator
is slightly raised, the doors are
easier to close.
Preventing doors from
being left ajar
Adjustable Support Cover
Insert the adjustable support cover
parallel to the floor all the way until
it reaches the end.
Left
Right
Left
Right
9
8
Summary of Contents for MR-WX60F
Page 86: ...Memo ...
Page 87: ...Memo ...