6
Space of 5 cm
or more
Space of 0.5 cm
or more
Install the refrigerator in the
following kind of location.
A place with good ventilation and
not exposed to direct sunlight or
hot air
To keep good cooling performance and
reduce power costs.
A place with low humidity
To prevent it from rusting.
A strong and level place
To prevent vibration, noise, and ajar or
tilting doors.
To prevent deformation or discoloration
of the floor materials due to the weight
or heat.
*If the floor materials are carpets, tatami
mats, wooden floors, PVC floors, etc.
and may deform or discolor, lay a
strong plate or board underneath.
A place away from other devices
To prevent noise or video interference
with devices such as televisions.
There should be at least 0.5 cm of
space on both the left and right
sides, and at least 5 cm of space
above.
To allow heat to dissipate from the top
and the sides of the refrigerator.
*The rear can be placed directly against
the wall. Leave some space if sound or
stain is a concern.
Installation
Leave space around the
refrigerator.
If refrigerant leaks, it may
accumulate and catch fire or
explode.
Follow the
instructions
Do not install the refrigerator
outdoors or in places exposed
to water or excessive humidity.
Water may cause insulation failure,
resulting in an electric shock or fire.
Water
prohibited
1
From Installation to Operation
Connect the Power Supply
* Connect power supply soon after installing the
refrigerator
Use a dedicated outlet
Use a dedicated outlet for the power supply that meets the rating
specified on the rating label. (The rating label is located on the
refrigerator compartment.)
Warning
Using outlets that do not meet the specified rating or
plugging in too many leads into a single socket can cause
heat buildup or fire.
The refrigerator will not be damaged even if the power is
supplied soon after installation.
It takes a while for the refrigerator to cool, therefore supply
power as soon as possible.
Electrical Connections
Make sure this unit is properly grounded.
The refrigerator should always be plugged into its
dedicated electrical outlet.
This will provide the best performance and prevent
electrical circuits from being overloaded and causing a
fire.
Make sure that the electrical outlet provides the proper
voltage.
Extension cords are not recommended.
If your refrigerator is installed in the high humidity
location, not only ground connection but also installation
of the earth leakage breaker is recommended.
If the power cord is damaged, purchase a new cord from
MITSUBISHI ELECTRIC SERVICE CENTRE or its
service agent. Make sure that the power cord is designed
for this model, in order to avoid a hazard.
If the power cord is damaged, contact MITSUBISHI
ELECTRIC SERVICE CENTRE or its service agent for
the replacement, in order to avoid a hazard.
2
Turn on the power of the
refrigerator as soon as
possible.
Dedicated
outlet that meets
the specified rating.
