- 51 -
(B) Interlocked registration information confirmation
After performing step
6
, proceed as follows:
B
B
C
Display the indoor unit address No. you want to confirm.
- Press the
H
[Time selection ( ) and ( )] buttons. The inter-
locked unit address decreases and increases. Set it to the in-
door unit address No. you want to confirm.
Displaying the LOSSNAY address No. interlocked at step
.
- Press the
E
[Timer selection (
)] button. The interlocked
LOSSNAY address No. and indoor unit address No. are alter-
nately displayed.
D
Displaying another registered unit address No.
- After step
C
, press the
E
[Timer selection (
)] button again.
Another registered unit address No. is displayed.
(The display method is the same as step
C
.)
(C) Returning to the normal state
When all the group registration and interlock registration operations
are completed, return to the normal state as described below.
Press and hold down the
[FILTER] and
B
[Louver
(
)
] buttons at the same time for two seconds. The re-
mote controller returns to the state of
1
.
(2) Registered address confirmation
Display the indoor unit address No. registered in the remote con-
troller by performing steps
1
and
2
.
Repeat steps
7
9
and
8
above to interlock all the indoor units
in a group with the LOSSNAY.
To return to the normal state,
go to step
0
.
To confirm the addresses, go
to (2) Registered address con-
firmation .
(A) Group registration information confirmation
A
Displaying “GROUP REGISTRATION”
- Each time you press the
E
[Timer selection (
)] button, the
registered indoor unit address No. and unit type are displayed.
<Registered>
<Not registered>
- When there is one registration, one address No. is displayed no
matter how many times the button is pressed.
- When there are multiple registrations (ex: 011 , 012 , 013 ,
the address Nos.) are displayed in 011
012
013 order each
time the
E
[Timer selection (
)] button is pressed.
Indicates the unit type.
(Indoor unit in this case.)
The above can also be confirmed similarly by displaying the LOSSNAY
address at the interlocked unit address.
Address of unit that is
interlocked
To delete an address, go to
(3) Address deletion
”
.
To return to the normal state,
go to step
0
.
(Alternate display)
Address of another
registered unit
(Alternate display)
To delete an address, go to
(3) Address deletion .
(3) Address deletion
Group registration information deletion deletes the indoor units registered in the remote controller.
Interlocked registration information deletion deletes the interlock between units.
Both deletion operations perform the address confirmation processing of (2) and are performed in the state in which the unit you want to delete was
displayed.
E
Deleting registered indoor unit or interlock between units.
- Press the
F
[Time selection(
CLOCK ON OFF
)] button two times in succession. The displayed indoor unit address or the interlock between units is
deleted.
When the information is deleted, the display shown below appears.
A
”
“
“
”
“
”
“
→
→
”
“
“
0
→ →
”
