18
7-1-2. Interlocked setting
• Sets each group for Interlocked operations with Interlocked unit.
• Perform the settings for the Interlocked unit after the groups have been set. Interlocked unit cannot
be set up for groups that do not have any units registered.
1
Call out the Interlocked unit setting screen
↓
2
Select the group number
Select the group for which interlocked unit is to be registered in the same way as for retrieval and
deletion.
3
Call out the registered unit
↓
4
Select the interlocked unit address number
↓
5
To register interlocked units
6
To delete interlocked units
7
To confirm interlocked units
↓
Refer to 7-1-1 or 7-1-3.
1
Call out the interlocked unit setting screen
(1)
Change the screen from the group selection screen shown in 7-1-1
1
to the interlocked unit setting
screen.
Press the
operation mode switch.
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
Initial settings mode screen
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
Interlocked unit setting screen
2
Select the group number
(1)
Call out the group number
• Call out the group number into which the interlocked unit is to be registered. Perform the same
procedure as explained in 7-1-1.
1
group selection.
• Select the group with the
and
GROUP select switch.
(2)
The relevant group number will be displayed in the room temperature display area once the group
has been selected.
[
] will be displayed two
seconds later
[
] will be displayed two
seconds later
Display area for the interlocked
unit address number
The screen will switch between the initial settings
mode screen and the interlocked unit setting screen
whenever the
operation mode switch is
pressed.
