26
(1) Setup menu
a) Function setting
1
Select "Unit IC (air conditioning units)" (*1) or "IF (Zone control interface)".
*1 The functions may not be available depending on model types.
2
When you select Function number which you want to confirm and touch [Conf]
button, the current setting contents are displayed in [Function setting] field.
• While monitoring contents for confirm, “Monitoring” is displayed.
• When the monitoring is completed, “Completed” is displayed.
• When the error happens, “Request denied” is displayed.
3
Select “Function mode number” you want to change the function, and select
“[Function setting]”.
• Please refer to indoor unit’s manual or "8.3. Function setting of zone control
interface" for the details.
4
When you touch [Set] button, change is set.
• While setting contents for change, “Setting” is displayed.
• When the setting is completed, “Completed” is displayed.
• When the error happens, “Request denied” is displayed.
b) Zone setting
1
Set the existence or not of Sub RC, Optional Sensor 1/2, Common zone.(Yes =
Existence, No = not connected)
After that, touch [Next] button.
2
Set the existence or not of zone1-8.
After that, touch [Next] button.
3
Select the zone you want to set in detail by touching [▼][▲] button in [Zone] field.
4
Select the sensor to assign to the zone [sensor] field.
5
Set the number of air outlets by touching [▼][▲] button in [Outlets] field.
6
Select spill zone setting in [Spill zone] field.
7
After all setting is done, touch [Done] button.
• When you select “Common” in [Zone] field, the following screen is displayed.
Set number of outlet for common zone.
When the zone setting is made, ensure that air blows out from the air outlet in
every zone by turning ON the zone one by one.
If the spill zone setting is made, in addition to the above, ensure that air blows out
from the air outlet in the spill zone after turning OFF all the zones.
8. Initial setting
<Fig. 8.2.2>
<Fig. 8.2.3>
<Fig. 8.2.4>
<Fig. 8.2.5>
<Fig. 8.2.6>
Mandatory
