– 8 –
<Selecting the Mode>
With the unit running, press the Mode button
2
as many times as necessary.
• Each press switches operation to the next mode, in the sequence shown below.
The currently selected mode is shown at
2
.
Note:
*1 Availability of this mode depends on the type of unit connected.
*2 Does not appear if Mode has been disabled at the Function Selection of remote
controller. For information about how to set this function, refer to section 6, item
[4]-2 (2).
<To Change the Temperature Setting...>
To lower the temperature: Press the
Set Temperature button
3
.
To raise the temperature: Press the
Set Temperature button
3
.
• Each press changes the setting by 1°C (1°F). The current setting is displayed at
3
.
• The available ranges are as follows. *1, *2
Note:
*1 Available ranges vary according to the type of unit connected.
*2 If temperature range limits have been set at Function Selection of remote
controller, the available ranges will be narrower than shown above. If you attempt
to set a value outside of the restricted range, the display will show a message
indicating that the range is currently restricted.
For information about how to set and clear these range limits, refer to section 6,
item [4]-2 (3).
*3 If Function Selection of remote controller are set to display the temperature in
Fahrenheit. For information about how to select °C or °F , refer to section 6, item
[4]-4 (1).
<Water Temperature Display>
During operation, the water temperature is shown at
4
.
Note:
To display range is 10°C to 90°C (50°F to 194°F).
If you are using the remote controller to drive multiple units, the display will show
the temperature at the main unit.
If water temperature display is disabled in Function Selection of remote controller,
the water temperature will not appear. For information about how to enable or
disable this feature, refer to section 6, item [4]-4 (2).
If Fahrenheit display is selected at Function Selection of remote controller, the
display will show the °F mark. For information about how to select °C or °F, refer to
section 6, item [4]-4 (1).
Heating mode
Hot Water
mode
Anti-freeze
mode
Cooling mode
Heating ECO
mode
20 - 90°C
(68 - 194°F) *3
20 - 90°C
(68 - 194°F) *3
5 - 45°C
(41 - 113°F) *3
5 - 30°C
(41 - 87°F) *3
Cannot be set.
Heating
*1*2
J
Heating ECO
*1*2
J
Hot Water
*1*2
J
Anti-freeze
*1*2
J
Cooling
*1*2
