3.[M-**] message code (Restoration possible)
*. When the control board presses the confirmation, the message code number lights to display panel of a set panel and the explanation is displayed in the liquid crystal panel. (The buzzer) rings intermittent.
*.When an [error code No.] is displayed, confirm the [message code No.] and investigate according to the following table.
*.The machine can be restored to [normal mode] by turning [on] the [C] key after confirming the content of the [message code].
Error Code
Message(state etc.)
Sub-message
(corresponding method etc.)
(Display)
M-001
*.The sewing machine has stopped at a stop position away from the normal UP stop position.
*.When the [C] key is turned [ON], the needle rotates in the forward direction and stops at
(Away by more than [+20 degrees] due to the sewing machine pulley.)
the normal UP stop position.
[Message]
NEEDLE NOT UP POSITION
[Sub Message] MAKE THE NEEDLE A UP POSITION
M-002
*.The needle thread trimming detection input signal (THS) has been input [ON].
*.Thread the needle thread and turn [ON] the [C] key.
[Message] NEEDLE THREAD BROKEN
[Sub Message] PLEASE PASS THE UPPER THREAD THROUGH THE NEEDLE
M-003
*.The presser foot is rising [OFF].
*.Lower [ON] the presser foot.
[Message] CLUMP UP POSITION
[Sub Message] TURN ON THE FOOT SWITCH (BLACK FOOT SWITCH)
M-004
*.The production number ((UP) counter) has reached the set value.
*.Turn [ON] the [C] key (enter key) and cancel.
[Message] UP COUNTER SETTING VALUE UP
[Sub Message]
M-005
*.(DOWN)counter has reached the set value.
*.Turn [ON] the [C] key (enter key) and cancel.
[Message] DOWN COUNTER SETTING VALUE UP
[Sub Message]
M-006
*.There is no sewing data in the current data area of the internal memory.
*.Turn [ON] the [C] key, and after turn [ON] the [D] key and read the pattern.
[Message] PATTERN DATA NOTHING
[Sub Message] READING OR TEACHING INPUT
M-007
[Message] NOT HOME POSITION CAN'T OPERATE
*.Turn [ON] the [H] key (return key).
[Sub Message] PRESS HOME KEY
M-008
[Message] SERIAL DATA TRANSMITTING...(RS232C)
[Sub Message] PLEASE WAIT FOR A WHILE
M-009
[Message] SERIAL DATA RECEIVING...(RS232C)
[Sub Message] PLEASE WAIT FOR A WHILE
M-010
[Message] HALT SW IS PRESSED
[Sub Message] PLEASE ROTATE THE HALT SWITCH RIGHT AND TURN OFF
M-011
[Message] PLEASE RUN SEWING MACHINE
[Sub Message] PLEASE ROTATE THE SEWING MACHINE BY THE WINDER OR
SEWING
M-012
[Message] HALT SW IS PRESSED POWER ON
[Sub Message] PLEASE TURN OFF THE POWER SUPPLY
M-013
[Message] NOW KEY LOCK
M-014
[Message] FUNCTION PROHIBITION SETTING (UCC) OF PRESENT VALUE IS ON
[Sub Message] PLEASE TURN OFF SETTING (UCC) WHEN CORRECTING.
