[8] - 5
B point ON
delay setting
(1)
When "invalid" is selected, the same signal as the A point will be output to the B point.
(2)
When "valid" is selected, the waveform will rise after the {set value x
100µs
} time (*1) set with the
A point input waveform. (ON delay)
Input signal A
“Invalid”
B
“Valid”
B
C point OFF
delay setting
(1)
When "invalid" is selected, the same signal as the B point will be output to the C point.
(2)
When "valid" is selected, the ON time will be delayed by the {set value x
100µs
} time (*2) set with
the B point input waveform.
Input signal B
“Invalid”
C
“Valid”
C
D point
Logic setting
(1)
When "normal" is selected, the C point signal will be output to the D point without any changes.
(2)
When "reverse" is selected, D point signal will be reversing signal of the C point signal.
Input signal C
Normal
D
“Reverse” D
E point
Chopping setting
(1) When [100%ON] is set, there is no change, and input signal of D point is output to E point.
(2) When other than [100%ON] is set, outpu of E point is on while {setting time x 100 us}. Afterwards the
output becomes square wave accordning to duty ratio setting.
Input signal D
“
100%ON
” E
“
Other than 100%ON
” E
100% ON
66% ON
（
8ms ON/4ms OFF
）
66% ON
（
4ms ON/2ms OFF
）
50% ON
（
4ms ON/4ms OFF
）
50% ON
（
2ms ON/2ms OFF
）
33% ON
（
2ms ON/4ms OFF
）
17% ON
（
2ms ON/10ms OFF
）
8% ON
（
2ms ON/22ms OFF
）
Manual setting
*1 Delay time to ON
*2 Delay time to OFF
Full wave time
Duty
Summary of Contents for PLK - G Series
