20
13. Electrical wiring
Warning:
(OHFWULFDOZRUNVKRXOGEHGRQHE\DTXDOL¿HGHOHFWULFDO
contractor in accordance with “Engineering Standards for
Electrical Installation” and supplied installation manuals.
If the power circuit lacks capacity or has an installation
IDLOXUHLWPD\FDXVHDULVNRIHOHFWULFDOVKRFNRU¿UH
Be sure to follow local and national code requirements
when wiring these units
Install the unit in a manner to prevent that any of the
control circuit cables (remote controller, transmission
cables) are brought in direct contact with the power cable
outside the unit.
Ensure that there is no tension on any wire connections
Some cables (power, remote controller or transmission)
above the ceiling may become damage by accident or by
animals. Use conduit as much as possible to prevent this.
Never connect the power cable to leads for the
transmission cables. The cables will be broken.
Be sure to connect control cables to the indoor unit,
remote controller and the outdoor unit.
Perform wiring in compliance with the safety regulations
detailed in UL 1995.
Be sure to install an earth leakage breaker to the
power.
Install the unit to prevent that any of the control circuit
cables (remote controller, transmission cables) is
brought in direct contact with the power cable outside
the unit.
Ensure that there is no slack on all wire connections.
Some cables (power, remote controller, transmission
cables) above the ceiling may be bitten by mouses.
Use as many metal pipes as possible to insert the
cables into them for protection.
Caution:
Be sure to ground the unit. Do not connect the grounding
cable to any gas pipe, water pipe, lightening rod, or
telephone earth cable. Incomplete grounding may cause a
risk of electrical shock.
If the supply cord is damaged, it must be replaced by
WKHPDQXIDFWXUHULWVVHUYLFHDJHQWRUVLPLODUO\TXDOL¿HG
persons in order to avoid a hazard.
([WHUQDO,2VSHFL¿FDWLRQV
Caution:
Wiring should be covered by insulation tube with
supplementary insulation.
Use relays or switches with IEC or equivalent standard.
The electric strength between accessible parts and control
circuit should have 2750 V or more.
Wiring
Electrical wiring to the air handler will come from
the outdoor unit. Please refer to the installation
instructions for the outdoor unit.
Caution:
DO NOT POWER THE ELECTRIC HEAT FROM THE
OUTDOOR UNIT. FOLLOW THE APPROPRIATE WIR-
ING SCHEMATIC FOUND IN THE ELECTRIC HEATER
INSTRUCTIONS.
Summary of Contents for PVA-A12AA7
Page 57: ...57 ...