12 - 1 12 - 1
MELSEC
12 APPLICATION FUNCTIONS
12 APPLICATION FUNCTIONS
Communication LX/LY
Automatic return function
Control station switch function
Control station return control function
Loopback function (optical loop system)
Diatnostic function
Low-speed cyclic transmission
Application
functions
Communication LB/LW
Basic
functions
Refer to Q Corresponding
MELSECNET/H Network System
Reference Manual
(PLC to PLC network)
········································································· Section 6.5
Driver WDT function ······································································· Section 4.3
·············································································
·····································································
···································································
······················································
·······················································
················································································································ Section 12.1
Section 12.2
Section 12.3.1
Section 12.3.2
Section 12.3.3
Section 12.4
Prevention of station failure by using external
power supply (optical loop system)
Cyclic transmission function
(Periodical communication)
RAS function
Multiple transmission function (optical loop system)
Cyclic transmission function
(Periodical communication)
Transient transmission function
(Non-periodical communication)
Direct access to link devices
Routing function
Group function
Communication function
12.1 Direct Access to the Link Devices
The link devices (LB, LW, LX, LY, SB, SW) of the MELSECNET/H board can be
directly read from/written to the user program by the driver setting.
By directly accessing the link devices, the link refresh time and the transmission delay
time can be shortened.
However, in direct access, since block guarantees are not applicable in station units, it
is necessary to establish an interlock.
For the direct access setting, set it in the "Driver" in the MNETH utility.
POINT
The direct access of the link devices LX/LY is limited to the communication with the
block I/O master station set with the common parameters. By limiting the
communication, data cannot be shared among multiple stations, such as link device
LB/LW, but 1:1 communication between predefined stations is allowed.
12
Summary of Contents for Q80BD-J71BR11
