2 - 4 2 - 4
MELSEC
2 SYSTEM CONFIGURATION
2.2.3 Setting items
In a single network system, the items which need to be set in the case that the
MELSECNET/H board is used as the control station or normal station are as follows.
MELSECNET/H board settings are set by the MNETH Utility.
Setting item
Control station Normal station Reference section
Channel setting
Section 9.2.2
Network No.
Section 9.2.3
Group No.
Station No.
Control station/ Normal station
Mode Setting
Routing parameter setting
Section 9.2.4
Common
parameter
setting
B, W setting
Section 9.2.5
X, Y setting
Reserved station setting
Supplementary setting
Opposite party setting
(Logical station No.)
Section 9.2.10
Driver setting
Section 9.2.11
: Setting necessary : Set as necessary : Setting unnecessary
2.2.4 Usable device ranges
The MELSECNET/H board can be used within the following device ranges for the
following devices on the MELSECNET/H board.
Device Usable
range
LB
0
H
to 3FFF
H
(16384 points)
The function expansion areas of 2000
H
to 3FFF
H
are used for
the low-speed cyclic transmission. All areas can be used for the
normal cyclic transmission.
The use ranges for each MELSECNET/H board and network
module need to be assigned in the parameter settings for the
control station.
LW
0
H
to 3FFF
H
(16384 points)
LX
0
H
to 1FFF
H
(8192 points)
The use ranges for each MELSECNET/H board and network
module need to be assigned in the parameter settings for the
control station.
LY
0
H
to 1FFF
H
(8192 points)
If the MELSECNET/H board is used in the MELSECNET/10 mode, the device range
for LB/LW becomes 0
H
to 1FFF
H
(8192 points).
Summary of Contents for Q80BD-J71BR11
