13
ERROR CODES
13
- 11
13.2 List of Error Messages in Device Monitor Utility
13.2 List of Error Messages in Device Monitor Utility
The following explains the corrective actions to error messages in the Device monitor
utility.
Error message
Corrective action
DEC input range error.
Input 0-9.
Input a decimal number in the range of 0 to 9.
HEX input range error.
Input 0-9, A-F.
Input a hexadecimal number in the range of 0 to 9, A to F.
Input Error.
Input 0-7
Input a octal number in the range of 0 to 7.
Station No. is not input.
Input a station number.
Station No. is out of the range.
Check the range of the station number, and Input.
The device that can use in this function dose not exist.
Select a device that can be used for the function.
Setting points are out of the range.
Check the range of the setting point, and Input.
Setting data are not input.
Input a setting data.
It cannot communicate XX : YY
Error code : ZZ (signed decimal)
Refer to the error list of MELSEC Data Link Library
Reference Manual.
Channel information is not register.
• Update the parameter again.
• Restart the developing environment (personal computer).
• Reinstall SW1DNC-MNETG-B.
It is fail to get the channel information.
• Update the parameter again.
• Restart the developing environment (personal computer).
• Reinstall SW1DNC-MNETG-B.
Device data are out of the range.
Check the setting of the device data.
Device No. is not input.
Input a device number.
Device No. is out of the range.
• Check the device number and set.
• Check the block number of the specified device (device
type).
• Check if the specified device and block number are valid
for the specified target.
Points are not input.
Input a point.
Network No. is not input.
Input a network number.
Network No. is out of the range.
Check the range of the network number, and input.
Block No. / Network No. is not input.
Input a block number.
Block No. / Network No. is out of the range.
Check the range of the block number, and input.
The necessary information is not found at the time of starting
up.
Install again.
The installation of SW1DNC-MNETG-B may be failed.
Reinstall SW1DNC-MNETG-B.